Solar street lamp, solar street lamp controller, battery
1: Exit protection voltage
Some customers often find that after the solar street lamp has been on for a period of time, especially after continuous rainy days, the street lamp will not be on for several days or even many days, the battery voltage is normal, and the controller and lamp are not faulty.
This problem has puzzled many engineers. In fact, this is the problem of the voltage value of "exit undervoltage protection". The higher the value is set, the longer the recovery time after undervoltage is, which also causes the failure of lighting for many days.
For this problem, the industrial controller allows each customer to set the voltage value of exit protection according to the configuration. However, it is worth noting that the configuration of the battery panel must be reasonable. If the daily charging capacity of the battery panel cannot meet the discharge capacity of the night, in the long run, the battery is often in deep discharge, and its life is greatly shortened. Therefore, the configuration of the battery panel must enlarge the margin. The larger the configuration of the battery panel, the lower the exit protection voltage can be set, which will not affect the battery.
2: LED constant current output
Due to its own characteristics, LED must be subject to constant current or current limitation by technical means, otherwise it cannot be used normally. Common LED lamps realize constant current of LED lamps by adding another drive power supply, but this drive accounts for about 10% - 20% of the total power of the whole lamp. For example, an LED lamp with a theoretical value of 42W, plus the actual power after driving, may be about 46-50W. When calculating the power of solar panels and battery capacity, it is necessary to add 10% - 20% more to meet the power consumption caused by the drive. In addition, the addition of drive will add a link that causes failure. The industrial version controller uses software to achieve constant current without power consumption, with high stability and low overall power consumption.
3: Output period
Ordinary controllers can only be set to turn off for 4 hours or 8 hours after the light is turned on, which can no longer meet the needs of many customers. The industrial controller can be divided into three periods, and the time of each period can be set arbitrarily. According to the different use environment, each period can be set to the closed state. For example, if some plants or scenic spots are unmanned at night, you can close the second period (late at night), or both the second and third periods, to reduce the use cost.
4: LED lamp output power regulation
Among the lamps used in solar energy, LED lamps are most suitable for realizing different output power through pulse width adjustment. While limiting the pulse width or current, adjust the duty cycle of the entire output of the LED lamp. For example, the LED lamp with a single 1W LED7 string of 5 and a total of 35W can be discharged at night, and the power can be adjusted separately in the late night and early morning, such as the late night to 15W and the early morning to 25W, and lock the current, which can not only meet the lighting of the whole night, but also save the configuration cost of the battery panel and battery. It has been proved by long-term tests that the heat generated by the whole LED lamp with pulse width adjustment mode is much smaller and can extend the service life of LED.